1901347 Авт. вимикач ETIMAT P10 3p D 6A (10kA)

The ETIMAT P10 circuit breaker from ETI is designed to protect electrical circuits against overload and short circuit conditions. It is intended for installation in distribution boards in residential, commercial, and industrial facilities where separate protection of three-phase lines is required. With 3 poles, the device provides simultaneous disconnection of all phases, which is important for safe operation of three-phase circuits and for isolating the supply line as a whole. The rated current of 6 A makes this circuit breaker suitable for low-load circuits and individual sections of wiring that must be protected according to their electrical characteristics. The D tripping curve indicates an increased instantaneous release threshold, so the device is appropriate for circuits with high inrush currents at startup. This is especially relevant for loads with a pronounced starting surge, where a standard trip curve may cause unnecessary switching off. The breaking capacity of 10 kA shows that the breaker is designed to interrupt short-circuit currents up to this level. This parameter is essential when selecting protective equipment for networks with higher fault current requirements, because it determines the device’s ability to safely disconnect the circuit under аварійних conditions. In practical use, the 10 kA rating makes the breaker suitable for distribution systems where elevated short-circuit currents are possible. ETIMAT P10 belongs to modular equipment and is mounted in a distribution panel together with other protective devices. Its three-pole design, 6 A rating, D characteristic, and 10 kA breaking capacity make it a technically defined solution for local or group protection of electrical lines. The breaker is used where reliable circuit separation and correct matching of protection parameters to the operating conditions are required.