2164508 Авт. вимикач ETIMAT 6 3p D 2A (6kA)

This ETI ETIMAT 6 automatic circuit breaker is designed to protect electrical circuits against overloads and short circuits in distribution boards used in residential, commercial, and industrial installations. With three poles, it is suitable for switching and protecting three-phase or multi-pole AC circuits, providing simultaneous disconnection of the line when an abnormal operating condition occurs. The device is rated at 2 A, which makes it intended for low-power circuits where precise current limitation is required. The D tripping characteristic indicates suitability for circuits with higher inrush currents, such as loads that can draw a short-term surge during start-up. This makes the breaker appropriate for applications where standard trip curves may react too early, while still maintaining reliable protection in fault conditions. The breaking capacity is 6 kA, allowing the breaker to interrupt short-circuit currents typical of many standard low-voltage networks. The rated AC voltage is 400 V, and the operating frequency is 50/60 Hz, so the device is designed for use in common alternating-current systems. The rated impulse withstand voltage Uimp is 6 kV, which reflects resistance to transient overvoltage events in the installation. For installation and wiring, the breaker supports a conductor cross-section range from 1 mm² to 25 mm², which provides compatibility with a broad selection of монтаж conductors used in electrical panels. The product complies with IEC/EN 60898-1 and IEC 60947-2 standards, confirming its intended use as protective switching equipment in standardized electrical systems. Overall, this 3-pole ETIMAT 6 breaker combines a low rated current, D curve, and 6 kA breaking capacity for protection of circuits where start-up currents must be taken into account. It is a practical choice for panel-mounted protection of selected AC lines requiring coordinated operation and compliance with widely used installation standards.