ETI ETIMAT 6 circuit breaker 2P 2A D 6kA (2163508)

The ETI ETIMAT 6 circuit breaker is intended for protection of AC electrical circuits against overload and short circuit. It is a two-pole device, so it can disconnect two conductors simultaneously, which is appropriate for circuits where complete line isolation is required. With a rated current of 2 A, this model is used in low-power circuits where precise limitation of load current is important. The D tripping characteristic means the circuit breaker is suitable for circuits with higher inrush currents. This is relevant for electrical equipment that briefly draws a current significantly above the nominal value during start-up. The breaking capacity of 6 kA allows the device to interrupt fault currents within the range typical for residential and part of commercial electrical networks, supporting protective disconnection under short-circuit conditions. The rated AC voltage is 400 V, while the rated frequency is 50/60 Hz, which makes the unit suitable for standard alternating-current installations. The rated impulse withstand voltage Uimp is 6 kV, indicating resistance to short-duration overvoltage impulses in the network. The permitted conductor cross-section range of 1 to 25 mm² provides flexibility when connecting cables or wires within the specified limits, simplifying installation in distribution boards and other modular assemblies. This automatic circuit breaker complies with IEC/EN 60898-1 and IEC 60947-2, confirming conformity with widely used requirements for low-voltage distribution and switching equipment. Thanks to its two-pole design, compact modular format, and defined electrical characteristics, the ETIMAT 6 series device can be applied in residential, administrative, and small industrial installations for branch circuit protection. It is suitable for use in electrical panels where separate line protection, reliable disconnection, and coordination with the load parameters are required.