ETI ETIMAT 6 Circuit Breaker 2P 1.6A D 6kA (2163507)

ETI ETIMAT 6 is an automatic circuit breaker designed for protection of electrical circuits against overloads and short circuits in AC networks. It is intended for installation in distribution boards of residential, commercial, and industrial facilities where controlled disconnection of a line under fault conditions is required. The two-pole design allows simultaneous switching of two conductors, which is important for circuit protection and convenient disconnection of the supply line. The rated current is 1.6 A, so this device is suitable for low-load circuits where precise current limitation is needed. The D tripping characteristic indicates use in circuits with high inrush currents, such as equipment that can create short-term current peaks during start-up. This makes the breaker appropriate for lines where standard response characteristics could lead to unnecessary tripping. The breaking capacity of 6 kA enables interruption of high short-circuit currents, which is essential for maintaining protective function in typical electrical installations. The device is rated for AC operation with a nominal voltage of 400 V and a frequency of 50/60 Hz. The rated impulse withstand voltage Uimp of 6 kV reflects the ability of the breaker to withstand transient overvoltages that may occur in the network. The rated conductor cross-section range of 1 to 25 mm² provides flexibility during wiring and allows use with conductors selected according to the project requirements. The model complies with IEC/EN 60898-1 and IEC 60947-2 standards, confirming its use in electrical distribution systems and modular switchboard assemblies. ETIMAT 6 is a practical solution for protecting individual lines where two-pole disconnection, defined electrical parameters, and compatibility with standard panel installations are required.