ETI ETIMAT 6 1P 10A D circuit breaker 6kA (2161514)

ETI ETIMAT 6 is a single-pole automatic circuit breaker intended for protection of electrical circuits against overload and short circuit in residential and commercial installations. With a rated current of 10 A, it is suitable for individual load groups where the electrical line requires defined protection and stable operation in a modular distribution board. The 1P design makes the device appropriate for single-phase circuits and compact panel layouts. The D tripping characteristic is used for circuits with higher inrush currents. This means the breaker can tolerate short-term current peaks that typically occur when switching on electric motors, transformers, and other equipment with elevated starting loads. Such behavior is important where a temporary current surge should not cause an unnecessary trip, while fault conditions still require fast disconnection. The breaking capacity of 6 kA indicates the ability to interrupt short-circuit currents within the range common for low-voltage systems. The device is designed for AC networks with a rated voltage of 230/400 V and a frequency of 50/60 Hz. The rated impulse withstand voltage Uimp is 6 kV, which is relevant when selecting protection equipment for networks exposed to transient overvoltages. The permitted conductor cross-section is 1–25 mm², providing flexibility during installation and connection in different distribution schemes. ETIMAT 6 complies with IEC/EN 60898-1 and IEC 60947-2, standards that define the requirements, testing procedures, and application scope for low-voltage circuit breakers. This makes the model suitable for use in lighting circuits, socket circuits, and other distribution lines where clear electrical parameters, standardized mounting, and compatibility with modular switchgear are important. The breaker is a practical solution for systems that require one-pole protection with a rated current of 10 A, D characteristic, and 6 kA breaking capacity.