ETI ETIMAT 10 automatic circuit breaker 2P 32A D 10kA (2153719)

The ETIMAT 10 automatic circuit breaker from ETI is intended for protecting electrical circuits against overload and short circuit in distribution boards used at residential, commercial, and industrial sites. Its two-pole design allows simultaneous switching of two conductors, which is important for single-phase lines and for circuits that require two-pole disconnection. This configuration makes the device suitable for use where coordinated disconnection of the protected line is necessary. The breaker is rated at 32A and has a D tripping characteristic. Such a characteristic is used in circuits with high inrush currents, where short-term current peaks appear during startup. For this reason, the device is suitable for protecting lines supplying equipment with electric motors, transformers, or other loads with elevated starting current. The 10kA breaking capacity enables the circuit breaker to interrupt high short-circuit currents, which is an important parameter for installations with increased protection requirements. The device operates in AC networks with a rated voltage of 400V and a frequency of 50Hz/60Hz. The rated impulse withstand voltage, Uimp, is 6kV, which indicates resistance to transient overvoltages in the electrical network. The permissible conductor cross-section ranges from 1 mm² to 25 mm², providing compatibility with a wide range of installation conductors within the specified limits. The product complies with IEC/EN 60898-1 and IEC 60947-2 standards, confirming its intended use in electrical distribution systems and modular protection assemblies. ETIMAT 10 combines a 2-pole configuration, 32A nominal current, D characteristic, and 10kA breaking capacity, making it a practical solution for protecting individual circuits that operate under conditions of increased starting currents and require reliable disconnection in AC installations.