2146518 Авт. вимикач ETIMAT 6 3p+N C 25А (6 kA)

This ETIMAT 6 automatic circuit breaker by ETI is designed to protect electrical circuits against overloads and short circuits in AC networks. The 3P+N configuration makes it suitable for three-phase lines with a neutral conductor, where simultaneous switching of the phase conductors and neutral is required. Such an arrangement is commonly used in distribution boards for residential, commercial, and small industrial installations. The device is rated at 25 A and features a C tripping characteristic, which is intended for circuits with moderate inrush currents. This makes it appropriate for protecting lines that may experience short-term current surges during equipment start-up. The breaking capacity of 6 kA allows the breaker to interrupt fault currents typical of low-voltage installations, providing protection in the event of a short circuit. The breaker is designed for a rated AC voltage of 400 V and a frequency of 50/60 Hz, so it can be used in widely applied three-phase power systems. The rated impulse withstand voltage, Uimp, is 6 kV, indicating resistance to transient overvoltage conditions that may occur in building electrical systems. The conductor cross-section range of 1 to 25 mm² supports use with a variety of cable sizes, depending on the requirements of the installation and the selected wiring scheme. Compliance with IEC/EN 60898-1 and IEC 60947-2 confirms its suitability for low-voltage electrical installations and modular switchgear assemblies. ETIMAT 6 is intended for installation in a distribution panel as part of the circuit protection system, where accurate trip parameters, three-phase compatibility, and conformity with technical standards are essential.