2146517 Авт. вимикач ETIMAT 6 3p+N C 20А (6 kA)

The ETIMAT 6 automatic circuit breaker by ETI is designed to protect AC electrical circuits against overloads and short circuits. It is intended for use in distribution boards in residential, commercial, and small industrial installations where switching and protective disconnection of three-phase lines with neutral are required. The 3+N pole configuration allows simultaneous control of three phase conductors and the neutral conductor, which is important for feeder and group circuits with the corresponding connection scheme. With a rated current of 20 A, this circuit breaker is suitable for lines with moderate load. Tripping characteristic C means it is designed for circuits with moderate inrush currents, such as equipment that draws a short-term current increase during startup. The breaking capacity of 6 kA enables interruption of fault current during short circuits within the range typical for most standard low-voltage networks. The device is rated for AC operation at 400 V and a frequency of 50/60 Hz. The rated impulse withstand voltage Uimp of 6 kV indicates resistance to transient overvoltages that can occur in the power supply during switching processes or lightning-related disturbances. The conductor connection range of 1–25 mm² makes it possible to use the breaker in different installation configurations depending on the cable or wire cross-section in the panel. The product complies with IEC/EN 60898-1 and IEC 60947-2 standards, confirming its suitability for power distribution systems and final circuit protection. ETIMAT 6 combines protection and switching functions with convenient integration into modular distribution boards, where compatibility with standard equipment and compliance with the parameters of the specific electrical network are essential.