2145518 Авт. вимикач ETIMAT 6 3p C 25А (6 kA)

The ETIMAT 6 automatic circuit breaker from ETI is intended for protecting electrical circuits against overload and short circuit in distribution networks of residential, commercial, and small industrial facilities. With three poles, it is designed for switching and protecting three-phase lines where simultaneous disconnection of all phases is required. The rated current of 25 A makes this device suitable for circuits with moderate load, while the C tripping characteristic is appropriate for lines with higher inrush currents, including motor-driven equipment and other loads that briefly draw increased current during start-up. The breaking capacity of 6 kA ensures circuit interruption under short-circuit currents typical for most domestic and commercial installations. The device is designed for AC systems, with a rated voltage of 400 V AC and operation on 50/60 Hz networks. The rated impulse withstand voltage Uimp of 6 kV indicates resistance to short-term overvoltage surges, which is important for reliable operation in electrical systems exposed to transient disturbances. This model complies with IEC/EN 60898-1 and IEC 60947-2 standards, which define the requirements for low-voltage automatic circuit breakers. This makes the product suitable for use in distribution boards as part of line protection and power distribution systems in accordance with applicable regulations. The conductor cross-section range of 1–25 mm² provides compatibility with widely used cable and conductor sizes, simplifying installation in switchboard assemblies. ETIMAT 6 is a modular device intended for installation in a distribution board, where it serves as a protective and switching element for individual feeder lines. The combination of three poles, 25 A rated current, C characteristic, and 6 kA breaking capacity makes it a practical solution for three-phase circuits that require both overload control and protection against fault conditions.