2143521 Авт. вимикач ETIMAT 6 2p C 50А (6 kA)

This ETIMAT 6 circuit breaker by ETI is designed to protect electrical circuits against overloads and short circuits in residential, commercial, and small industrial installations. With two poles, it enables simultaneous switching of two conductors, which is especially relevant for AC circuits and for lines where full disconnection of the supply is required. The 50 A rated current makes the device suitable for circuits with increased load, while the C tripping characteristic supports use in circuits with moderate inrush currents, including applications where connected equipment may draw a short-term starting current. The breaking capacity of 6 kA allows the device to interrupt fault conditions under short-circuit currents typical for many low-voltage distribution networks. The breaker is rated for AC operation at 400 V, with a network frequency of 50/60 Hz, matching common power supply parameters in alternating-current installations. The rated impulse withstand voltage Uimp of 6 kV indicates resistance to short-duration overvoltage events that may occur during switching operations or from external disturbances. For wiring integration, the device accommodates conductors with a cross-section from 1 to 25 mm², which simplifies installation in different distribution board configurations. It complies with IEC/EN 60898-1 and IEC 60947-2 standards, confirming conformity with the technical requirements and performance expectations for modular protective devices. This makes the breaker suitable for installations where adherence to normative electrical protection requirements is important. In practice, the ETIMAT 6 is used as a protective element for feeder and branch circuits in distribution panels, helping isolate a damaged line without interrupting the operation of other circuits. Its two-pole design, 50 A rating, C curve, 6 kA breaking capacity, and AC 400 V specification define a clear scope of application for circuit protection in standard low-voltage systems.