2136701 Авт. вимикач ETIMAT 10 3p+N C 0,5А (10 kA)

ETIMAT 10 by ETI is an automatic circuit breaker designed to protect electrical circuits against overload and short circuit. It is intended for use in distribution boards in residential, commercial, and industrial installations where reliable disconnection of a line under fault conditions is required. The 3P+N configuration allows simultaneous control of three phase conductors and the neutral, which is especially relevant for three-phase circuits with a neutral conductor. The device has a rated current of 0.5 A, so it is suitable for circuits with low load where precise protection is needed. The C tripping characteristic means the breaker is designed for networks with moderate inrush currents. This makes it appropriate for lines where short-term current peaks may occur during equipment start-up. The breaking capacity of 10 kA provides interruption of the circuit even in the event of high short-circuit currents, which is an important parameter for electrical system protection. The breaker is rated for AC voltage of 400 V and a frequency of 50/60 Hz, so it is compatible with standard AC power networks. The rated impulse withstand voltage Uimp of 6 kV indicates resistance to short-duration surge overvoltages. The permitted conductor cross-section range of 1 to 25 mm² allows use with a wide range of cable sizes within the specified technical limits. The model complies with IEC/EN 60898-1 and IEC 60947-2 standards, confirming its suitability for power distribution and circuit protection applications. With its defined electrical parameters and 3P+N pole arrangement, this ETI circuit breaker is a practical choice for protecting individual lines in switchboard assemblies where coordination of phase and neutral conductors is required.