2133722 Авт. вимикач ETIMAT 10 2p C 63А (6 kA)

This two-pole automatic circuit breaker from the ETIMAT 10 series by ETI is designed to protect electrical circuits against overloads and short circuits. It is intended for installation in distribution boards of residential, commercial, and other low-voltage networks where simultaneous disconnection of two conductors is required. With a rated current of 63 A, the device is suitable for circuits with elevated load levels, while the C tripping characteristic makes it appropriate for circuits with moderate inrush currents, including loads that may briefly draw current above the normal operating level. The breaking capacity of 6 kA allows the breaker to interrupt fault currents within the range typically found in standard electrical networks. The device is designed for operation in AC circuits with a rated voltage of 400 V and a frequency of 50/60 Hz. The rated impulse withstand voltage Uimp is 6 kV, which is important for the device’s resistance to short-duration overvoltage events in the network. This model complies with IEC/EN 60898-1 and IEC 60947-2 standards, confirming its suitability for power distribution and electrical installation protection applications. The permissible conductor cross-section is 1–25 mm², which allows the breaker to be integrated into different wiring schemes using cables and conductors of the appropriate size. Its modular design supports mounting on a DIN rail inside a distribution board together with other protection and control devices. ETIMAT 10 is a practical solution for protecting individual lighting circuits, socket circuits, and power circuits where two-pole switching, a 63 A rating, and operation in an AC 400 V network are required.