2133715 Авт. вимикач ETIMAT 10 2p C 13А (10 kA)

This modular circuit breaker from the ETIMAT 10 series by ETI is designed to protect AC electrical circuits against overloads and short circuits. It is a two-pole device, which allows simultaneous switching of two conductors and is suitable for circuits where two-pole disconnection is required. With a rated current of 13 A, it is intended for distribution boards protecting lines with moderate loads, including lighting and power circuits in residential, commercial, and other low-voltage installations. The C tripping characteristic means the device is adapted for circuits with relatively higher inrush currents. This is important for lines supplying equipment with short-term startup loads, such as electrical receivers that draw current briefly at switch-on. The breaking capacity of 10 kA enables the breaker to interrupt the circuit under high short-circuit current conditions, making it suitable for networks with corresponding fault current levels. The device operates in AC networks with a rated voltage of 400 V and a frequency of 50/60 Hz. The rated impulse withstand voltage Uimp is 6 kV, which is an important parameter for electrical protection in conditions where transient overvoltages may occur. The permitted conductor cross-section for connection is 1–25 mm², providing compatibility with a broad range of wiring solutions during the assembly of distribution equipment. The circuit breaker complies with IEC/EN 60898-1 and IEC 60947-2 standards, confirming its suitability for use as low-voltage modular protective equipment. It is typically used as a local protection element for individual consumer groups in apartment, house, and commercial electrical panels where compact circuit protection and switching are required.