2133710 Авт. вимикач ETIMAT 10 2p C 4А (10 kA)

The ETI ETIMAT 10 circuit breaker is designed for protection of electrical circuits against overloads and short circuits. It is used in distribution boards of residential, commercial, and small industrial installations where reliable disconnection of a two-pole line is required in AC networks. With two poles, the device allows simultaneous switching of two conductors, which makes it suitable for corresponding single-phase or two-wire circuits. The rated current is 4 A, so this circuit breaker is intended for low-power lines where precise current limitation is important. The C tripping characteristic indicates suitability for circuits with moderate inrush currents, including equipment that may draw a short-term current increase at startup. This characteristic helps the device operate correctly in applications where temporary load peaks are expected during switching on. The breaking capacity of 10 kA enables interruption of fault currents with a high short-circuit level, which is especially relevant for installations with increased prospective fault currents. The breaker is designed for AC operation with a rated voltage of 400 V and a frequency of 50/60 Hz. Such parameters make it applicable in standard low-voltage distribution systems. The rated impulse withstand voltage Uimp is 6 kV, which indicates resistance to short-term overvoltage events occurring in the power network. This parameter is important for maintaining the electrical endurance of the switching device in real operating conditions. For conductor connection, the device supports a rated cross-section from 1 to 25 mm², allowing integration into various wiring solutions. The product complies with IEC/EN 60898-1 and IEC 60947-2 standards, which define requirements for low-voltage circuit breakers. ETIMAT 10 is a practical solution for circuit protection and switching in panel equipment where clearly defined electrical characteristics and compliance with standard norms are required.