2123715 Авт. вимикач ETIMAT 10 2p B 13А (10 kA)

The ETIMAT 10 series automatic circuit breaker by ETI is designed to protect electrical circuits from overloads and short circuits. It is used in distribution boards for residential, commercial, and industrial installations where reliable disconnection of a line during fault conditions is required. The two-pole design allows simultaneous switching of two conductors, which is important for suitable single-phase or two-wire circuits. The rated current of 13 A defines the device’s application in circuits with moderate load. The B tripping characteristic is suitable for circuits with low inrush currents, such as lighting lines and other consumers that do not require increased tolerance to short-term current peaks. This makes the breaker appropriate for branch circuits where fast response to overload and short-circuit events is needed without unnecessary delay. The breaking capacity of 10 kA enables the device to interrupt circuits under high short-circuit currents, expanding its use in networks with increased fault-current levels. The breaker is intended for AC systems with a rated operational voltage of 400 V and a frequency of 50/60 Hz. The rated impulse withstand voltage Uimp of 6 kV indicates resistance to impulse overvoltages that may occur in the electrical network. The connection range for conductors with a cross-section from 1 to 25 mm² allows this model to be integrated into different wiring schemes depending on circuit requirements and installation conditions. Compliance with IEC/EN 60898-1 and IEC 60947-2 confirms that the device belongs to low-voltage protection equipment and meets the requirements for circuit protection in standardized electrical installations. ETIMAT 10 is a practical solution for selective protection of individual consumer groups and for building the protection structure of distribution assemblies in domestic and professional electrical panels.