2123712 Авт. вимикач ETIMAT 10 2p B 6А (10 kA)

The ETIMAT 10 series device from ETI is intended for protecting AC electrical circuits against overload and short circuit. With a two-pole design, it is suitable for circuits where two conductors need to be switched simultaneously. The rated current of 6 A makes this circuit breaker appropriate for lines with low load, including lighting circuits and other single-phase consumers in residential, administrative, and small commercial installations. The B tripping characteristic indicates that the device disconnects the circuit within a range suitable for loads with low inrush currents. This makes it well matched to circuits where stable operation is required without unnecessary tripping during normal switching events. A breaking capacity of 10 kA allows the breaker to operate in networks where high short-circuit currents may occur, helping protect both the wiring and connected equipment. The model is designed for AC systems with a rated voltage of 400 V and a frequency of 50/60 Hz, so it can be used in standard power distribution networks. The rated impulse withstand voltage Uimp of 6 kV adds resistance to short-duration voltage surges, which is important for installation in distribution boards. The permitted conductor cross-section range of 1–25 mm² provides flexibility when connecting cables within the specified technical limits. Compliance with IEC/EN 60898-1 and IEC 60947-2 confirms that the device meets the requirements for use in modular distribution boards and electrical installations. This makes it a practical solution for branch-circuit protection where two-pole disconnection, a 6 A rating, B characteristic, and 10 kA breaking capacity are required.