1901430 Авт. вимикач ETIMAT P10 3p+N C 16A (10kA)

The ETIMAT P10 circuit breaker from ETI is designed to protect electrical circuits against overload and short circuit in distribution boards used in residential, commercial, and small industrial facilities. It is intended for installation in modular switchboards and serves as a protective device for individual lines or groups of loads where reliable circuit disconnection is required under fault conditions. This model has a 3P+N pole configuration, meaning three poles for the phase conductors plus a neutral pole. Such a layout is suitable for three-phase AC networks with a separate neutral conductor, where simultaneous switching and protection of the circuit are necessary. The rated current is 16 A, which makes the device appropriate for circuits with moderate load levels. The C tripping characteristic indicates suitability for circuits with inrush currents, such as lines feeding equipment that may briefly draw higher current at startup. The breaking capacity is 10 kA, allowing the breaker to interrupt high short-circuit currents and providing an important level of protection for modern electrical installations. The device is rated for AC operation at 415 V and a frequency of 50/60 Hz. Its rated impulse withstand voltage Uimp is 6 kV, which reflects resistance to short-duration voltage surges that may occur in the electrical network. For connection, the breaker supports conductor cross-sections from 1 mm² to 25 mm², which offers flexibility when integrating it into different wiring schemes. The product complies with EN/IEC 60898, confirming its intended use in household and similar low-voltage installations. ETIMAT P10 3P+N C16 is therefore a practical choice for protecting three-phase circuits with neutral where 16 A rated current, C curve tripping, and 10 kA breaking capacity are required.