Circuit breaker ETI ETIMAT P10 3P+N 6A C 10kA (1901427)

The ETI ETIMAT P10 is an automatic circuit breaker designed to protect AC electrical circuits against overload and short circuit. It is intended for installation in distribution boards and is suitable for three-phase lines with neutral, where simultaneous switching and protection of multiple conductors is required. The 3P+N configuration means the device has three poles for phase conductors and one neutral pole, which makes it applicable in residential, commercial, and small industrial electrical installations. With a rated current of 6 A, this circuit breaker is used in low-load circuits where precise limitation of current is important. The C tripping characteristic allows it to operate properly in circuits with moderate inrush currents, which is useful for loads that draw a short-term current increase at startup. This makes the device appropriate for protecting lines with equipment that can create temporary current peaks during switching on. The breaking capacity of 10 kA provides the ability to disconnect high short-circuit currents, which is an important parameter for ensuring circuit protection in installations with higher fault-current levels. The breaker is rated for 415 V AC and a frequency of 50/60 Hz, so it is suitable for standard AC power systems. In addition, the rated impulse withstand voltage Uimp of 6 kV indicates resistance to short-duration overvoltage events in the network. The nominal conductor cross-section range of 1–25 mm² should be taken into account during design and connection in the switchboard. The device complies with EN/IEC 60898, which confirms its use in the category of automatic circuit breakers for low-voltage distribution systems. Thanks to its 3P+N design, C6 tripping curve, 10 kA breaking capacity, and AC operating type, the ETIMAT P10 is a practical solution for protecting three-phase circuits with neutral in modern electrical distribution assemblies.