1901426 Авт. вимикач ETIMAT P10 3p+N C 4A (10kA)

The ETI ETIMAT P10 circuit breaker is designed to protect electrical circuits against overload and short-circuit conditions. It is intended for installation in distribution boards of residential, commercial, and small industrial facilities where a separate device is required to disconnect a three-phase line with neutral. The 3+N pole configuration allows simultaneous switching of three phase conductors and the neutral, which is practical for group circuits and loads connected to AC networks. With a rated current of 4 A, this device is suitable for circuits with low operating current. The C tripping characteristic makes it appropriate for networks where short-term inrush currents may occur, such as when switching on equipment with electric motors or other inductive loads. This helps maintain a balance between protective sensitivity and tolerance to temporary start-up surges. The breaking capacity of 10 kA indicates the breaker’s ability to interrupt high fault currents in systems with the corresponding short-circuit level. The rated AC voltage is 415 V, and the rated frequency is 50/60 Hz, which makes the unit suitable for standard three-phase alternating-current systems. The rated impulse withstand voltage Uimp is 6 kV, reflecting resistance to impulse overvoltages in the electrical network. The device complies with EN/IEC 60898, the standard for modular circuit breakers used in household and similar installations. The rated conductor cross-section of 1 mm² to 25 mm² provides flexibility when selecting the connection size within the specified range. ETIMAT P10 is a functional solution for circuit protection where accurate tripping parameters, sufficient breaking capacity, and compatibility with three-phase systems with neutral are required.