1901348 Авт. вимикач ETIMAT P10 3p D 10A (10kA)

This automatic circuit breaker from the ETIMAT P10 series by ETI is designed to protect electrical circuits against overloads and short circuits. It is intended for installation in distribution boards used in residential, commercial, and other electrical installations where reliable disconnection of a three-phase line or another three-pole circuit is required. With three poles, the device ensures simultaneous switching of all phases, which is important for proper operation and protection of the network. The model is rated for a nominal current of 10 A and has a D tripping characteristic. This characteristic is suitable for circuits with higher inrush currents, such as loads that briefly draw a significantly higher current during start-up. It helps prevent nuisance tripping while maintaining circuit protection. The breaking capacity of 10 kA allows the device to interrupt fault currents during short circuits in networks where substantial current loads may occur. The breaker is designed for AC circuits, with a rated operating voltage of 415 V and a frequency of 50/60 Hz. Its rated impulse withstand voltage, Uimp, is 6 kV, indicating resistance to transient overvoltages typical of low-voltage electrical networks. The permissible conductor cross-section ranges from 1 to 25 mm², which makes the device compatible with a wide range of cable and wire terminations used in switchboards. The product complies with EN/IEC 60898, the standard governing circuit breakers for household and similar installations. This compliance confirms its suitability for use in systems where electrical protection, switching performance, and conformity to installation requirements are important. ETIMAT P10 3P 10A D 10kA is a practical solution for circuit protection in applications that require a three-pole breaker with a D curve and a high breaking capacity.