1901304 Авт. вимикач ETIMAT P10 3p B 2A (10kA)

This circuit breaker from the ETIMAT P10 series by ETI is designed to protect electrical circuits against overloads and short circuits. It is suitable for distribution boards in residential, commercial, and other electrical installations where three-phase line protection with a low operating current is required. With three poles, the device enables simultaneous switching of three conductors, which is important for AC networks and for coordinated disconnection of multi-conductor circuits. The model is rated for a nominal current of 2 A and has a B tripping characteristic. This means it is intended for circuits with relatively low inrush currents and provides prompt response when overload or short-circuit conditions occur. The breaking capacity of 10 kA makes it suitable for installations where higher prospective short-circuit currents may be present, helping ensure that the protective device can interrupt fault current within the specified limits. The breaker is designed for AC voltage networks with a rated operating voltage of 415 V and a frequency of 50/60 Hz. Its rated impulse withstand voltage Uimp is 6 kV, which is relevant for equipment exposed to switching surges and transient overvoltages. The permissible conductor cross-section range is 1 to 25 mm², allowing connection to a broad selection of cable and wire sizes within the stated limits. Compliance with EN/IEC 60898 confirms that the device belongs to the category of modular circuit breakers intended for household and similar installations. This makes the ETIMAT P10 3P 2A B 10kA a suitable solution for protecting individual three-pole lines in electrical distribution systems where reliable disconnection, standard compliance, and compatibility with modular panel mounting are required.