1901254 Авт. вимикач ETIMAT P10 2p D 40A (10kA)

The ETIMAT P10 circuit breaker from ETI is designed to protect AC electrical circuits against overload and short circuit. With a two-pole design, it allows simultaneous switching of two conductors, which is appropriate for circuits where disconnection by both poles is required. This type of device is commonly used in distribution boards in residential, commercial, and light industrial installations to protect individual feeders and load groups. The rated current is 40 A, so the device is suitable for circuits with higher operating loads within the specified electrical limits. The D tripping characteristic means the breaker is intended for circuits with significant inrush currents, where short-term current peaks may occur during equipment start-up. The breaking capacity of 10 kA enables the breaker to disconnect the circuit under high short-circuit currents, helping protect wiring and connected equipment. The device is rated for 230 V AC and 50/60 Hz, making it suitable for standard single-phase AC networks. The rated impulse withstand voltage, Uimp, is 6 kV, indicating resistance to short-duration voltage surges that may appear in the network. The specified rated conductor cross-section is 125 mm², which is an important parameter when selecting conductors and planning the connection in accordance with project requirements. The model complies with EN/IEC 60898, a standard that defines requirements for circuit breakers used in household and similar applications. This makes the breaker suitable for modular distribution boards where clear line protection, stable electrical characteristics, and compliance with installation standards are required.