ETI ETIMAT P10 Circuit Breaker 2P 6A D 10kA (1901247)

ETIMAT P10 from ETI is an automatic circuit breaker intended for protecting AC electrical circuits against overload and short circuit. It is designed for installation in distribution boards and other modular assemblies where individual line protection and simultaneous disconnection of two conductors are required. With 2 poles, this device is suitable for single-phase or two-wire circuits, making it applicable in lighting circuits, socket groups, and other small-power consumer lines. The rated current is 6 A, which makes the breaker appropriate for circuits with relatively low operating load. The D tripping characteristic indicates suitability for circuits with higher inrush currents, for example when connected equipment draws a short-term current peak during start-up. This feature is important where standard trip curves may cause unwanted disconnection under normal start-up conditions. The breaking capacity of 10 kA allows the device to interrupt high short-circuit currents, expanding its use in networks with increased protection requirements. The breaker is designed for AC voltage with a rated operating voltage of 415 V and a rated frequency of 50/60 Hz. The rated impulse withstand voltage Uimp of 6 kV reflects resistance to short-term overvoltage events, which is relevant for operation in electrical panels and distribution systems. The product complies with EN/IEC 60898, the standard covering circuit breakers for household and similar installations. According to the provided parameters, the permissible conductor cross-section ranges from 1 to 25 mm², which supports connection of different cable sizes depending on the circuit design. The unit belongs to the ETIMAT P10 2p D6 series and is identified by article number 1901247. This circuit breaker is used in residential, commercial, and technical installations where dependable protection of a separate line is needed. Its combination of 2 poles, 6 A nominal current, D curve, 10 kA breaking capacity, AC operation, 415 V rating, and 6 kV impulse withstand voltage defines its scope of application in modular low-voltage distribution equipment.