1901048 Авт. вимикач ETIMAT P10 1p D 10A (10kA)

The ETIMAT P10 series circuit breaker from ETI is designed to protect AC electrical lines against overload and short circuit conditions. It is used in distribution boards for residential, administrative, and commercial installations where one individual circuit needs to be disconnected with defined load parameters. The single-pole design makes it suitable for protecting a separate phase conductor in single-phase networks or as part of a larger modular assembly in a switchboard. This device is rated for a nominal current of 10 A and features a D tripping characteristic. Such a curve allows the breaker to tolerate short-duration inrush currents without nuisance tripping, which makes it appropriate for circuits with inductive loads or equipment with higher starting current. The breaking capacity of 10 kA is an important protective parameter, as it indicates the breaker’s ability to interrupt high short-circuit currents and disconnect the circuit under severe fault conditions. The model is intended for AC systems with a rated voltage of 240 V and a frequency of 50/60 Hz. The rated impulse withstand voltage Uimp is 6 kV, confirming resistance to transient overvoltages within the device’s application class. The allowable conductor cross-section of 1–25 mm² provides flexibility during installation and enables connection to conductors within the specified technical range. The product complies with EN/IEC 60898, the standard governing circuit breakers for household and similar installations. This makes the device suitable for use in switchboards where accurate tripping behavior, electrical endurance, and compliance with established safety requirements are essential. With its combination of a 1P configuration, 10 A rating, D curve, and 10 kA breaking capacity, it serves as a functional solution for protecting individual electrical circuits in modern low-voltage distribution systems.