Circuit breaker ETI ETIMAT P10 1P 2A D 10kA (1901044)

The ETI ETIMAT P10 circuit breaker is designed to protect electrical circuits against overload and short circuit in residential, commercial, and industrial distribution boards. It is used for switching and protecting individual feeder lines, especially where a separate protective device is required for a single-phase circuit. With one pole and a rated current of 2 A, this device is suitable for low-power loads and circuits with limited current consumption. The tripping characteristic D indicates that the breaker is intended for circuits with higher inrush currents. This makes it appropriate for equipment that may draw a short-term current surge at startup, while still needing reliable protection during normal operation. The breaking capacity of 10 kA allows the device to disconnect high short-circuit currents, which is an important parameter for electrical installations with increased fault-current levels. The breaker operates on AC voltage and is rated for 240 V at 50/60 Hz. It also has a rated impulse withstand voltage Uimp of 6 kV, which reflects resistance to short-duration voltage surges in the network. These electrical characteristics make the device suitable for use in standard low-voltage distribution systems where stable operation and circuit protection are required. Compliance with EN/IEC 60898 confirms that the device is intended for low-voltage overcurrent protection in final circuits. The terminal range of 1–25 mm² allows connection of conductors within the specified limits, providing flexibility during installation. ETIMAT P10 belongs to the ETIMAT P10 1p D2 category and is a modular circuit breaker designed for mounting in distribution panels, where compact dimensions and standardized installation are important.